Engine Compartment Lid

 

Rubber bumper to keep trunk from hitting deck lid

Rubber bumper to keep trunk from hitting deck lid

This is the NLA rubber "bumper" that keeps the rear trunk lid from hitting the engine deck lid. You will need the metal angle bracket that holds this in place, as it is not included.

914 Engine deck lid edge protectors

914 Engine deck lid edge protectors

This is a set of all 3 edge pieces that keep the metal edges covered.

914 Engine deck lid welting enough for all 3 sections

914 Engine deck lid welting enough for all 3 sections

This is the rubber "gasket" seal that isolates the grill from the body and deck lid. Most of these have been pained over or ar in very poor repair. Now you can replace all 3 sections cheap. NLA OEM

Speednut set of 14 for letters

Speednut set of 14 for letters

This is a complete set of 14 speednuts that can be used to attach the letters to the grill.

Engine Deck Lid Bumper Set 914.559.253.10

Engine Deck Lid Bumper Set 914.559.253.10

These are the long sought after engine deck lid bumpers that are NLA. You can get them here and inexpensively.

 

Engine Deck Lid Seal

Engine Deck Lid Seal

This is the "seal " that you see between the back glass and the deck lid. It hides the gap, and keeps water from rolling directly in the opening.

pull for deck lid machined delrin

pull for deck lid machined delrin

This is the engine deck lid pull only. If your base is good and you only need the knob, this is what you need.

914 Rear deck lid relaease cable

914 Rear deck lid relaease cable

This is a direct replacement for the rear deck cable cable, it has a threadded termination that will screw right into the handle base to allow you to pull. This typically fails at the latch portion where the stress is at the termination there. I...

Engine deck lid base for pull 914.512.177.10

Engine deck lid base for pull 914.512.177.10

This is the machined base for the engine deck lid pull. It holds the back pad to the fireall in this area also.

914 Early rain tray pre 74 more sturdy than stock 914.512.189.10

914 Early rain tray pre 74 more sturdy than stock 914.512.189.10

This is a reproduction of early rain tray. These are more sturdy than the OEM ones as the material has a higher melting point and is thicker. Don't forget the rubber bumper that keeps the rear trunk lid from hitting this. I have them reproduced...

Late Rain tray 91451218910

Late Rain tray 91451218910

This is our reproduction of the rain trays that keep your engine compartment from getting wet. They superceeded the early version (which we also make), and look identical to factory. We did however make them slightly thicker and out of a better...

Rain tray drain tubes set of 2 PCG 571 900 00

Rain tray drain tubes set of 2 PCG 571 900 00

This is a set of drain tubes that are needed to allow the water to drain from the rain tray through the engine compartment. The funnels and grommets are not included with these. It is not 100% correct for the OEM hose, butismuch c,oser than the...

Engine bay rain tube funnel Grommets set of 2 914.572.913.10

Engine bay rain tube funnel Grommets set of 2 914.572.913.10

These are the funnel tube grommets that hold the tube in place on the sheetmetal. These are made from silicone so that they should hold up a little better that the OEM version. These NLA pieces will dress up your engine shelf nicely, why reuse your crusty old rubber ones if you don't have to?