Front Trunk Parts

Wiring cloth tape - for harness 180'

Wiring cloth tape - for harness 180'

If you arere wrapping your wiring harness, this is the stuff you want. 180' roll (best value)

Front trunk guide tube and pull cable

Front trunk guide tube and pull cable

This is a set of the front trunk release tube and the pull cable that goes in it. If your tube is cracked it allows the wire to flex making it dificult to open the front trunk. They were NLA from factory for some time so I decided to make them....

914 Front trunk cable - Cable only

914 Front trunk cable - Cable only

This is the front trunk cable only for the 914. It is a direct replacement for the OEM. These usually fail at the attachmnet point in the release mechanism. Making the cable just a little too short. Both the engine deck lid cable and the front...

Front trunk guide tube only (NO CABLEINCLUDED)

Front trunk guide tube only (NO CABLEINCLUDED)

This is for the front trunk guide tube only. The cable is shon in the picture BUT IS NOT INCLUDED.

I listed this for people that just need the tube.

Front trunk carpet kit - with plywood insert

Front trunk carpet kit - with plywood insert

This is a two piece front trunk kit made of perlon. It unilke others mine comes with the plywood attached so you can drop it in. Includes the tire board and comes in Black or Charcoal. Selcet no board to get jsut the perlon and re use your board.

914 Front trunk Bulkhead seal

Same as set only excludes main seal

This is the upper "bulkhead seal" infront of the gas tank that runs from strut to strut. Available without buying the entire set. $18 compare to OEM at $50, only mine has an aluminum clip and is slightly taller for a better seal.

914.572.913.10 Front trunk bulkheads sealing grommet set of 2

914.572.913.10 Front trunk bulkheads sealing grommet set of 2

This is a set of 2 new front trunk bulkhead seals. These are mostly deteriorated on many cars that have them. These will make an airtaight seal with new hoses. If you elect to us ethe OEM (paper and aluminum), you may want to trim the inner lip...

914 Airbox rebuild kit (without screen)

914 Airbox rebuild kit (without screen)

This replaces the flapper valve seals, the seal between the upper and lower housings, and the upper edge seal that isolates the box front the body to keep it from rubbing.

Airbox rebuild kit with late (grill type) top seal

Airbox rebuild kit with late (grill type) top seal

This is the seals you will need to rebuild the airbox flappers, and seal the bower unit to the upper section. It also includes the molder top seal that holds the grill in place. Others use a seal that is cut and glued in the corners for a fit...

914 Fresh air box top seal (SEAL ONLY)- Late for use with grill

914 Fresh air box top seal (SEAL ONLY)- Late for use with  grill

This is the seal that goes on the top of the airbox that holds the grill in place. The early cars do not have the grills but you can add one by changing out this seal and including a new plastic grill.

 

Late Airbox Grill

Late Airbox Grill

Reproduction airbox grill for use with the late syle top seal. 

Airbox drain tubes set of 3 PCG 571 900 00

Airbox drain tubes set of 3 PCG 571 900 00

These are the air box drain tubes NOT sourced at your local hardware store. They are actually ribbed and make a very firm attachment onto the fittings. The T fitting is shown on the assembly, however, it is NOT included.

Blower to mixing box hose set

These are the hoses that connect the mixing boxes to the air blower. Set of 2, They are an upgrade from the paper and aluminum OEM hoses, as they are significantly more durable.

Hoses from blower to mixing box.914.571.123.10 set of 2

Hoses from blower to mixing box.914.571.123.10 set of 2

These are the hoses that are in the front trunk that go from the mixing box to the lower vent. OEM Part number 914.571.123.10 Not the flimsy paper and aluminum hoses others sell. 

914 Long to blower heater hose set of 2914.572.123.10

914 Long to blower heater hose set of 2914.572.123.10

This is the hose set that goes from the longs (by drivers and passengers feet) through the bulkhead into the blower motor. These are not the flimsy paper and aluminum hoses that are available at the local parts store. This is a set of 2 - $42

Passenger side heater hose (single hose) 930.211.622.01

Passenger side heater hose (single hose) 930.211.622.01

This is the longer of the 2 blower hoses that connects the blower to the passenger side heat exchanger.

Although both hoses are actually black, it is the black hose in the picture.

Vent hose bushing 823823591 999.702.049.50 set of 2

Vent hose bushing 823823591  999.702.049.50 set of 2

Long extinct grommet in the firewal for the vent line into the charcoal canaster.

Also known as 823823591 999.702049.50

 

SET OF 2 

Drivers side heater hose (single hose) PCG.261.233

Drivers side heater hose (single hose) PCG.261.233

This is the shorter of the 2 blower hoses that connects the blower to the drivers side heat exchanger.

Although shown as the orange hose it is actually black

Defroster seals (set of 2)

Defroster seals (set of 2)

Closed cell foam seals to replace the OEM ones that are not available

901-628-923-01 Wiper Grommet Female - Set of 2

901-628-923-01 Wiper Grommet Female - Set of 2

This is a gasket that has been way overpriced for too long. Help me make these and other more afordable parts with your purchase today!

 

part number 901.628.923.01

Wiper grommet male set of 2 901.628.924.00

Wiper grommet male set of 2 901.628.924.00

This is a listing for the male grommets in the wiper assembly. It is for a set of 2. These have application for 911, 924, 928, and 944's.

901.628.926.00 Wiper cap

901.628.926.00 Wiper cap

While you are replacing your wiper grommets might as well replace these. Most are in poor shape 

914.628.012.55 mount for wiper assembly

914.628.012.55 mount for wiper assembly

This is the piece that is often damaged during removal as it's not easly seen. That is is it's still intact. 40 years of vibration has taken it's toll on most of these. Now you can replace yours. It is often purchased with the airbox rebuild kit...

Windshield wiper Grommet set of all 4

Windshield wiper Grommet set of all 4

This listing is for a set of wiper grommets for your 911, 914, 924, 928, 930 or 944. These at list price would run you about $46 for the set. That's why many put off replacing these. Now you can replace all for a fraction of the price.

Porsche Windshield Washer Squirter

Porsche Windshield Washer Squirter

Replacement nozzle for windshield sprayers. Available in black (reproduction) or chrome (OEM). Sold individually.

Windshield washer offset isolator standoff

Windshield washer offset isolator standoff

If you've done a bare metal restoration, you may well be familiar with this part. probably 80% of all the cars out there have the factory original offset isolators. Most have deteriorated and cracked if not sheared. Mine actually split in 2....

914 GT Headlight release cable assembly

914 GT Headlight release cable assembly

This is a kit that is used to replace your headlight motors. Nice way to reduce the weight if you are autocrossing or concerned about weight. Also just a neat kit if you want something different or are making a GT clone.

914 Expansion Tank Gasket

914 Expansion Tank Gasket

This fits between the expansion tank and the gas tank.

914 Early gas cap seal

914 Early gas cap seal

A simple solution for replacement of your early cap seal. Made from solvent resistant rubber. An inexpensive fix for the gas smell if you cap leaks.

Early cap only

914 late gas cap seal

914 late gas cap seal

Mine was missing and I wondered why I could smell gas when I cornered. Fits late gas caps

477919133 Seal for VDO sender gauge 911 914 944

477919133 Seal for VDO sender gauge 911 914 944

This is a replacement seal for your VDO fuel sending unit. 477919133 477-919-133 477 919 133 477.919.133