Generator Single Parts

 

914 Alternator positive boot cap

914 Alternator positive boot cap

This is the cap that is critically important to the harness in that it keeps the positive terminal from grounding out onto the back of the cooling plate. Inexpensive to replace. 

alternator harness electrical clip for harness (each)

alternator harness electrical clip for harness (each)

This is the clip that goesinto the alternator itself and to the main board. The one at the board is usually ok but the one on the unit tends to fail over time due to heat. Easy to replace. These are sold individually.

Alternator wiring harness 70-76 4 cylinder only plug and play

Alternator wiring harness 70-76 4 cylinder only plug and play

This is a direct replacement fro your old worn out wirring harness. If you replace your alternator you more than likely will need the rubber, now you can eliminate any potential problems by simply replacing. Correct gage wires used along with new...

(1)

Alternator wiring harness 70-76 With Cover Group Buy

Alternator wiring harness 70-76 With Cover Group Buy

This is a direct replacement fro your old worn out wirring harness. If you replace your alternator you more than likely will need the rubber, now you can eliminate any potential problems by simply replacing. Correct gage wires used along with new...

914 Alternator harness grommet

914 Alternator harness grommet

These are the grommets that go on the wirring harness at the tin behind the alternator, and at the sheetmetal on the engine. This is for one grommet. Check out this product and more on our new site: https://900designs.zoeysite.com/alternator-wiring-harness-grommet-1-1

Alternator Inspection Cover

Alternator Inspection Cover

Plastic cover for the fan housing to allow access to the alternator top bolt. For adjustment with engine installed. Helps keep airflow directed for cooling. Check out this product and more on our new site: https://900designs.zoeysite.com/alternator-inspection-cover

Alternator Cooling Boot

Alternator Cooling Boot

Elbow cooling hose for the alternator, used from 1973-76.This is the one without the retaining clip inside the cooling housing. Check out this product and more on our new site: https://900designs.zoeysite.com/alternator-cooling-boot