Wiring Harnesses

 

914 Alternator positive boot cap

914 Alternator positive boot cap

This is the cap that is critically important to the harness in that it keeps the positive terminal from grounding out onto the back of the cooling plate. Inexpensive to replace. 

alternator harness electrical clip for harness (each)

alternator harness electrical clip for harness (each)

This is the clip that goesinto the alternator itself and to the main board. The one at the board is usually ok but the one on the unit tends to fail over time due to heat. Easy to replace. These are sold individually.

Alternator wiring harness 70-76 4 cylinder only plug and play

Alternator wiring harness 70-76 4 cylinder only plug and play

This is a direct replacement fro your old worn out wirring harness. If you replace your alternator you more than likely will need the rubber, now you can eliminate any potential problems by simply replacing. Correct gage wires used along with new...

(1)

Alternator wiring harness 70-76 With Cover Group Buy

Alternator wiring harness 70-76 With Cover Group Buy

This is a direct replacement fro your old worn out wirring harness. If you replace your alternator you more than likely will need the rubber, now you can eliminate any potential problems by simply replacing. Correct gage wires used along with new...

Oil Temp Wiring Harness Grommet

Oil Temp Wiring Harness Grommet

New reproduction of the wire grommet for the oil temp sender wire on the taco plate. Used for all 914 model years, 1 required per car. 311.949.149.A, 311 949 149 A, 311-949-149-A, 311949149A On a VW Type 34, two of these are required to seal the...

914 Wiring harnes snorkel tube

914 Wiring harnes snorkel tube

This is the part you need to seal the tunnel area behind the firewall to the engine tin. I made it long enough that it should fit most 6 applications, but will still work for the 4. Made from durable silicone. Check out this product and more on...

AP consul wiring harness for 3 guage in stock configuration.

AP consul wiring harness for 3 guage in stock configuration.

This is a plug and play wirring harness for the center consul 3 gage set up. It comes with directions to help you install. Check out this product and more on our new site: https://900designs.zoeysite.com/center-console-wiring-harness

Wiring cloth tape - for harness 180'

Wiring cloth tape - for harness 180'

If you arere wrapping your wiring harness, this is the stuff you want. 180' roll (best value)

Wiring Tab Cover. Correct gloss fits well per 1'

Wiring Tab Cover. Correct gloss fits well per 1'

Correct wiring harness tab covers.  Soft rubber with correct gloss level and it actually grips and holds well. It takes about 9' for every tab on your car.

Headlight bucket wiring anti chafing grommet material set of 2

Headlight bucket wiring anti chafing grommet material set of 2

This is a set of 2 enough for both sides.

Battery block positive terminal - optional hardware and stud

Battery block positive terminal - optional hardware and stud

This is the NLA battery block that is used on the positive terminal. It's NLA but you can get one here inexpensively. The current configuration allows for the option to add the stud and hardware if you do not have them.They do not come with...